Hardware Components, Inc.

All Metal Alloys
ferrous and non-ferrous, are castable in the Sand Casting process. This fact coupled with low tooling cost make this the process of choice for low-volume products or new items where volume is unpredictable. Its drawbacks are the wider tolerances (+/- 1/32") and much heavier wall thickness' than are required by die or investment casting. Where close tolerances, thin walls and smooth surface finish are not required, sand casting is often the most economical means of production. Good casting integrity (lack of porosity) machinability, and low initial tooling costs characterize this process.

Sand Castings

Stainless Steel
Malleable Iron
Ductile Iron
Aluminum


Home

Hardware Components, Inc.
1021 Park Avenue
New Matamoras, Ohio 45767 USA
Phone: 740-865-2424
Fax: 740-865-2534
E-mail:hci@hardwarecomponents.com